C&G 2921-34 Design and installation of domestic and small commercial electric vehicle charging installations.

The UK is aiming to become net-zero by 2050. The transport sector is one of the UK’s largest emitters of CO2 and a major source of air pollution in cities. Decarbonizing transport is, therefore essential if the UK is to meet its goal of net zero emissions by 2050, one of the primary drivers enabling this strategy is through the Electric Vehicles. Sales globally for Electric vehicles have significantly increased over the last 3 years. The result of more electric cars on the road requires an infrastructure in place for car users to charge their vehicles at their convenience.

Course Overview

• Introduction, BS 7671 section 722 and the current IET Code of Practice
• Modes of charging, EV Supply Equipment, restrictions
• Installation practices, risk assessment, earthing, protection, labelling
• On street and small commercial situations
• Inspection, testing, fault finding & maintenance
• Certification & notification to DNO

Entry Requirements

We cannot accept any registrations for candidates under 18 as these qualifications are not approved for under 18s.  This course is intended for practicing electricians.

Learners must hold one of the following:

• City & Guilds Level 3 NVQ Diploma in Installing Electrotechnical Systems and Equipment (Buildings, Structures and the Environment) (2357)
• City & Guilds Level 3 NVQ Diploma in Electrotechnical Services (Electrical Maintenance) (2357)
• City & Guilds Level 3 Electrotechnical qualification (5357)
• City & Guilds Level 3 NVQ in Electrotechnical Services Experienced Worker (2356)
• City & Guilds Level 3 Electrotechnical Experienced Worker Qualification (2346)
• City & Guilds Level 3 Electrotechnical in Dwellings Experienced Worker Qualification (2347)
• Other Awarding Organisations equivalences will also be acceptable
• Equivalent historical qualifications Electrotechnical Assessment Specification or Electrotechnical Assessment Specification
• ECS Gold Card issued by the JIB or SJIB – Installation Electrician, Maintenance Electrician, or Domestic Electrician

For learners in Scotland:

• Any of the above or
• SVQ in Electrical Installation at SCQF level 7

For learners in Wales:

• Any of the above or
• EAL Building Services Engineering (Level 3) Electrotechnical Installation For all learners, the qualifications above must have been achieved no more than 5 years prior to starting this qualification or there must be evidence the learner has remained current by holding the latest edition of the Wiring regulations qualification.

Exams & Assessments

Course Materials

On attendance of the course, you will need the following:

• IET Code of Practice for Electric Vehicle Charging Equipment Installation (5th Edition)
• IET Wiring Regulations 18th Edition A2:2022